SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Drive pulley /cgi-bin/YaBB.pl?num=1218506292 Message started by 88pagan on 08/11/08 at 18:58:12 |
Title: Drive pulley Post by 88pagan on 08/11/08 at 18:58:12 Ok I'm sorry to have to do this but I went through about the first 10 pages of each category and tried searching "drive" "pulley" "drive pulley"..I just CANNOT find the post I ran across a couple of days ago. I saw a post about the drive pulley and retorquing it and someone catching it just in time before it wore through the teeth on the output shaft. I just want to know what size that biga$$ nut is so I can buy a socket when I'm at work tomorrow. I'm pretty sure we don't carry it but when I find it I don't want to waste my time buying the wrong one..thanks in advance for any response. |
Title: Re: Drive pulley Post by serowbot on 08/11/08 at 19:16:25 http://suzukisavage.com/cgi-bin/YaBB.pl?num=1166804153 32mm, torque is 130Nm |
Title: Re: Drive pulley Post by verslagen1 on 08/11/08 at 19:32:03 harbor freight has a set of 6point 3/4 drive sockets that'll do everything for the cost of 2 sockets from sears, fork caps to rear axle. remember to get the adapter set to. ;D |
Title: Re: Drive pulley Post by 88pagan on 08/11/08 at 20:06:33 darn, thanks guys. Gonna pull that engine tomorrow! Hope my output shaft looks good..add too much to the list and the bike's almost getting parted out..haha |
Title: Re: Drive pulley Post by serowbot on 08/11/08 at 22:17:09 Remember, that's a lefty/tighty, righty/loosey nut on there... |
Title: Re: Drive pulley Post by Kropatchek on 08/14/08 at 09:27:31 1006110C14010C17630 wrote:
Sorry to correct you!!!!! It's normal RH thread ::) |
Title: Re: Drive pulley Post by serowbot on 08/14/08 at 09:49:38 ...sorry, my bad. It's the crank gear that's reverse, right? Thanks for the correction. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |