SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Wild Question /cgi-bin/YaBB.pl?num=1218143885 Message started by Red_Wine on 08/07/08 at 14:18:04 |
Title: Wild Question Post by Red_Wine on 08/07/08 at 14:18:04 Hello fellow Savagers, I know it may sound strange, but do you think a 400cc cylinder may be bored to 650cc? I wonder if I can use the cylinder I have and adapt it to accept a 650 piston and the corresponding head and valves. I ask because the engines are very similar, but I am not sure if my 400 has enough "meat" to take that kind of machining... Food for thought... Thanks, RW |
Title: Re: Wild Question Post by verslagen1 on 08/07/08 at 14:27:38 Compare the bore and stroke between the 2 and I think you'll see that the stroke is different between the 2. And if you did bore it out from 400 to 650, I think the piston will be visible. I know it's a stretch to go from 650 to 700 on ours. |
Title: Re: Wild Question Post by Paladin. on 08/07/08 at 16:35:18 The LS650 is a square 94mm x 94mm bore x stroke. What is the LS400?? |
Title: Re: Wild Question Post by klx650sm2002 on 08/09/08 at 01:48:43 As far as I know the 400 is a short stroke 650. Clive W |
Title: Re: Wild Question Post by dasch on 08/09/08 at 02:12:58 ... and if that is the case, you need a 650 cylinder and 650's crankshaft, to push/pull piston up and down further... Maybe a few other pieces... |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |