SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Getting stuck at red lights - Question
/cgi-bin/YaBB.pl?num=1215808556

Message started by Mr. Hyde on 07/11/08 at 13:35:55

Title: Getting stuck at red lights - Question
Post by Mr. Hyde on 07/11/08 at 13:35:55

I picked up a couple of magnets today because I've been having trouble with the local traffic lights. Where exactly should they be mounted?  

Title: Re: Getting stuck at red lights - Question
Post by SimonTuffGuy on 07/11/08 at 14:34:27

I believe most are mounted on the lowest section of the frame... Think about where your bike stops when you're at a redlight, and where the sensor boxes would be located.

I'd guess around the kickstand or engine/tranny section somewhere?

Title: Re: Getting stuck at red lights - Question
Post by verslagen1 on 07/11/08 at 17:24:07

I think it was old feller that mounted them to the topside of the kickstand pad.  It seemed to work for him.  and if nothing else, if you see a 15 lb. sledge hammer in the road just roll by and it will pick it up.   ;D

Title: Re: Getting stuck at red lights - Question
Post by SuziQ on 07/12/08 at 04:47:10


07386402332E2F4A0 wrote:
I picked up a couple of magnets today because I've been having trouble with the local traffic lights. Where exactly should they be mounted?  

Most are mounted on the section of the frame reserved for the California Emission Canister.  Don't use this flat platform for anything else as it isn't strong enough to lift the bike with a jacking device.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.