SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Brass plug? /cgi-bin/YaBB.pl?num=1214013092 Message started by Doug A on 06/20/08 at 18:51:32 |
Title: Brass plug? Post by Doug A on 06/20/08 at 18:51:32 Hi guys... Sorry if this has been asked before... How do I get the brass plug out so I can adjust the pilot screw? Thanks... Doug. |
Title: Re: Brass plug? Post by justin_o_guy2 on 06/20/08 at 18:57:05 1/8th drill bit, tape around it, so the bit doesnt run thru & mess up the screw, |
Title: Re: Brass plug? Post by Sandy Koocanusa on 06/20/08 at 19:51:11 I only drilled through far enough to baaaarely penetrate the back of the plug. Didn't make the full 1/8 inch hole all the way through. Then I used a gold sheet rock screw, as soon as the screw started turning the plug, I gave it a yank and out it came. |
Title: Re: Brass plug? Post by Doug A on 06/20/08 at 19:57:07 Thanks fo the info! I'll make sure I don't drill too deep. |
Title: Re: Brass plug? Post by rpgpgmr on 06/22/08 at 09:07:21 That's exactly how I did it. Worked like a charm! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |