SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> legnth of valve cover bolts? /cgi-bin/YaBB.pl?num=1211847959 Message started by horseshoe_george on 05/26/08 at 17:25:58

Title: legnth of valve cover bolts? Post by horseshoe_george on 05/26/08 at 17:25:58 The tech ref section suggests one replace the bolts that hold the valve adjusting covers on with new ones. It indicates that they are M6 with a 1.0 pitch. Does anyone know the legnth of the bolts? Thanks.

Title: Re: legnth of valve cover bolts? Post by T Mack 1 on 05/27/08 at 13:13:22 I would suggest you take one of the four out and measure it.   They  are not real long , maybe an inch or inch & a half or so.   But, they're metric so your best bet is to measure it.

Title: Re: legnth of valve cover bolts? Post by vroom1776 on 05/28/08 at 05:28:47 .

Title: Re: legnth of valve cover bolts? Post by KwakNut on 05/28/08 at 06:08:34 50574A4B5D4B50575D675F5D574A5F5D380 wrote: The tech ref section suggests one replace the bolts that hold the valve adjusting covers on with new ones. It indicates that they are M6 with a 1.0 pitch. Does anyone know the legnth of the bolts? Thanks. What reason is given for replacing them? - the only bolts that usually require replacement are one-off stretch bolts under high loads, certainly not the case with those cover screws!

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.