SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Removing Turning Signals /cgi-bin/YaBB.pl?num=1211411525 Message started by Coleman on 05/21/08 at 16:12:04 |
Title: Removing Turning Signals Post by Coleman on 05/21/08 at 16:12:04 I looked in the tech section but I didn't see any guides to removing the turning signals on my 97 Savage. I did notice that the newer ones don't that that dumb looking rubber post. Am I going to have to take off the whole side pieces that connect up to the sissy bar? If so I'm gonna be kinda ticked since I just installed my new saddlebag supports. |
Title: Re: Removing Turning Signals Post by makk98 on 05/21/08 at 16:20:55 i think there is a screw on the underside of the side bracket that locks the light in place. |
Title: Re: Removing Turning Signals Post by Coleman on 05/21/08 at 17:32:53 Yeh there is one on the side of the light but it is what holds the rubber to the light itself. |
Title: Re: Removing Turning Signals Post by newrider55 on 05/21/08 at 18:24:36 There is also a screw on the underside of the fender rails. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |