SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Carb White Spacer Dimensions /cgi-bin/YaBB.pl?num=1211339848 Message started by saratovich on 05/20/08 at 20:17:27 |
Title: Carb White Spacer Dimensions Post by saratovich on 05/20/08 at 20:17:27 When I had the carb worked on, the needle spacer was replaced with a .060 shim . . . I still experience backfiring, but not as loud. I'm looking to change the exhaust and out of curiosity, pulled out the calipers and measured the stock part. Figured I share the info. Perhaps it will be useful to someone looking for mods without have the carb torn apart. http://tinyurl.com/4m53z4 |
Title: Re: Carb White Spacer Dimensions Post by jomiyo on 05/21/08 at 05:33:27 I was actually at the hardware store looking for a new smaller spacer the other day and i didn't get anything because i wasn't sure what size the infamous white spacer was. no i can go back on my mission tonight. - does that spacer have to be a special material? |
Title: Re: Carb White Spacer Dimensions Post by Baldeagle on 05/21/08 at 13:09:16 Replaced my spacer with a 3/32 sec. metal washer. |
Title: Re: Carb White Spacer Dimensions Post by jomiyo on 05/21/08 at 13:13:41 What is your setup... exhaust, jet sizes, intake. elevation? i am just trying to be prepared for anything so i am not out of riding for more than a day or two. |
Title: Re: Carb White Spacer Dimensions Post by verslagen1 on 05/21/08 at 14:07:14 5F5A585C4C5A350 wrote:
all to often, full lancer set, alternately, upright. [smiley=evil.gif] |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |