SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> handlebar adjustment /cgi-bin/YaBB.pl?num=1210004642 Message started by Dice on 05/05/08 at 09:24:02 |
Title: handlebar adjustment Post by Dice on 05/05/08 at 09:24:02 Quick question for anyone willing to help, I'm new to this site and I tried searching for this with no luck. I would like to adjust my handlebars a bit but I'm not sure how to get the caps off of the hex/allen bolts without gumming them up. Didn't know if there was an easy way to do it. thanks Dice |
Title: Re: handlebar adjustment Post by Keith_T on 05/05/08 at 13:15:04 They pry up pretty easily if you use a small screwdriver to get under one side. I long finger nail may even work. They are only held in place by friction inside the allen head of the bolt. |
Title: Re: handlebar adjustment Post by Bear_Rider on 05/05/08 at 15:44:37 I just had mine off last week. The key is patience. If you can get it started just a little with a fingernail, then you can work a thin object under them and lift. Work your way around each caps, lifting from several positions. Cheer up. Getting them back on is a snap. ;D However, you might want to leave the caps in a baggie in your tool box until you are certain that you have the bars where you want them. Don't ask me how I came by this pearl of wisdom. I should have the bandaid off my finger in next few days. |
Title: Re: handlebar adjustment Post by Dice on 05/05/08 at 18:53:29 Thanks guys got them off tonight and adjusted them going to go for a ride in the morning so hopefully they are right where I need them do the bolts have to be torqued back down? and if so how many ftlbs? Dice |
Title: Re: handlebar adjustment Post by steely on 05/06/08 at 18:54:11 I always start mine by sliding a razor blade up underneath them. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |