SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Engine Stalling
/cgi-bin/YaBB.pl?num=1206920034

Message started by Onederer on 03/30/08 at 16:33:54

Title: Engine Stalling
Post by Onederer on 03/30/08 at 16:33:54

After running the Savage 80mph for hours with ocasional 90mph burst, after a wot run then pulling in the clutch to coast to a intersection, then engine stalls. After restarting the engine, it runs fine. Had this happen a couple of times. Has anyone else had the same happen? Its not in the neutral safety system, and the bike runs fine otherwise.

Title: Re: Engine Stalling
Post by verslagen1 on 03/30/08 at 16:40:41

same answer different person...

turn up the idle speed hot rod.

Title: Re: Engine Stalling
Post by Reelthing on 03/30/08 at 19:45:10

make real sure the vac line is sealed to the petc0ck - try the same haularse procedure with it on PRI - so far as the idle - while it sounds cool down around 800-1k thump thump thmp you know - the best idle so far as the machine goes is where the headlight does not dim at idle on high beam - you can tell it watch the light - rev a little - if it gets brighter your idle is to low for best results so far as the machine goes -
if you idled right and it dies after a haularse close the throttle - add 1/8 turn to the mixture and try it again

Title: Re: Engine Stalling
Post by justin_o_guy2 on 03/30/08 at 21:28:33

If I pull the clutch in running over 65 it dies every time, Unless I keep the throttle in it a bit.

Title: Re: Engine Stalling
Post by verslagen1 on 03/30/08 at 21:39:11

I think it's quite normal for the rpm's to dip abit after an extended run of any rpm's. The engine pulled a vacuum while it was idling down staving for gas and air. Takes awhile to catch up. These are not fuel injected you know. Monitored and compensated for everything.