SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> rear turnsignals 2006 s40
/cgi-bin/YaBB.pl?num=1206745871

Message started by kasper on 03/28/08 at 16:11:11

Title: rear turnsignals 2006 s40
Post by kasper on 03/28/08 at 16:11:11

How do you remove the rear turn signals on the s40? Just bought a 2006 and need to replace the rear signal... sounds simple, but

Title: Re: rear turnsignals 2006 s40
Post by demin on 03/28/08 at 16:14:47

You have to take the chrome bracket/or sissy bar whichever you have off to get to the wiring.There is a phillips head screw underneath where the t/s meets the bracket.Look underneath you'll see it.

Title: Re: rear turnsignals 2006 s40
Post by thumperclone on 03/28/08 at 16:28:50

wiring runs under the fender side rails towards the front..easier to get to the nuts with rear wheel up off ground unless you have small hands ,nuts for the side rails are insde of fender.if i remember corectly pull the seat to get to the wiring junction/splice /connector point..if bike has sissy bar(didnt come stock on 06) have to remove it first, look up under where sb meets side rail for phillips head screw..