SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> risers /cgi-bin/YaBB.pl?num=1202325469 Message started by vwvan on 02/06/08 at 11:17:48 |
Title: risers Post by vwvan on 02/06/08 at 11:17:48 need help putn on deuce risers im not to bright i put the bolts thru after i drill out the top and bottom caps but do i need to put back in the spacers that were in the middle of the rubber things |
Title: Re: risers Post by verslagen1 on 02/07/08 at 21:30:57 the spacers are there so you can tighten the nuts down so they don't vibrate off. And when you do, they ensure the bars are properly isolated. If the stock spacers don't fit on the new bolts, get new spacers the same length. |
Title: more risers Post by vwvan on 02/06/08 at 11:26:22 also the bottom of the risers have about an inch nipple so thought that i would drill the top cap so it sits down in flush and drill out the rubber also to make it sit flush thanks for readn this i dont want to pay dealer to do it |
Title: Re: more risers Post by verslagen1 on 02/07/08 at 21:32:33 File them off. |
Title: Re: risers Post by Rockin_John on 02/09/08 at 00:33:45 Sounds like you got some hard to fit risers. The H-D risers I've used just mounted with a long 1/2"-20 bolt; and only required drilling out the chrome caps over the rubber isolators so that the 1/2" bolts would go through. Some pictures of what you're working with sure would help! :D |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |