SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Seized Mixture screw /cgi-bin/YaBB.pl?num=1201536783 Message started by Jimworx on 01/28/08 at 08:13:02 |
Title: Seized Mixture screw Post by Jimworx on 01/28/08 at 08:13:02 Does anyone have any ideas on how to remove a seized mixture screw on the carb? The previous owner stripped the head of the screw and it appears to be seized in there. Any ideas? Thanks, Jim |
Title: Re: Seized Mixture screw Post by KwakNut on 01/28/08 at 08:29:21 Take a look at the Jardine muffler re-jet thread just below here - the answer's in there. |
Title: Re: Seized Mixture screw Post by Cornerstore3000 on 01/28/08 at 08:34:17 Always, always use anti-seize on anything that doesn't have to be thread locked. Its cheap and will save you a ton of headaches. |
Title: Re: Seized Mixture screw Post by justin_o_guy2 on 01/28/08 at 08:50:48 If you dont have a Dremel clone, now would be a good time. Big Lots hooked me up with one I am pretty danged satisfied with, tho one of the bushings was drilled off center & the tool wobbles, but it has worked flawlessly & that one bushing is not needed often. Cost about $40.00, maybe Hobby Lobby or some hobby store, model airplane shop. Then you can reach in there & put a good groove in the screw head. Squirt some good slick stuff in there. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |