SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Saddle bag supports
/cgi-bin/YaBB.pl?num=1200000134

Message started by DocNeedles on 01/10/08 at 13:22:13

Title: Saddle bag supports
Post by DocNeedles on 01/10/08 at 13:22:13

I recently purchased a set of LS650 saddle bag supports off ebay. They are in their original package but one flange for attaching to the fender is at about 45 degrees while all of the other are at 90 degrees. Their is no splitting of the shiny surface and I was wondering if this is normal for this one flange attachment or should it also be at 90 degrees?
DocNeedles

Title: Re: Saddle bag supports
Post by bill67 on 01/10/08 at 14:28:52

Mine are both at 90 unless where talking about something different.

Title: Re: Saddle bag supports
Post by thumperclone on 01/10/08 at 17:23:16

06 oem the 4 flat parts(2 per side) where the bolt goes thru are 90 deg up and 45 deg forward..after inslalled the down round support rods angle back from the fender bolt bout 45 deg..hope this helps

Title: Re: Saddle bag supports
Post by T Mack 1 on 01/10/08 at 18:40:04

Hmmmm.... don't have SB's but a picture on this one would be worth a thousand words (literally).

Title: Re: Saddle bag supports
Post by DocNeedles on 01/10/08 at 19:25:43

213D203825302736393A3B30550 wrote:

06 oem the 4 flat parts(2 per side) where the bolt goes thru are 90 deg up and 45 deg forward..after inslalled the down round support rods angle back from the fender bolt bout 45 deg..hope this helps

So Thumperclone, my bike is a 1986 Savage, will these work on it? There is only one 45 degree angle on the long tab of one of the supports.
DocNeedles

Title: Re: Saddle bag supports
Post by thumperclone on 01/11/08 at 13:04:18

hold them up to the side rails (orient left and right they slant to the back of the bike)your holes should line up withe the rail bolts..the supports mount inside the fender you may need longer bolts dont knw my bike came with the supports installed..just dont go too long MUST maintain tire clearance...im still not clear on whats at a 45deg on yours...good luck!! let us know how it comes out..btw whats the sellers return policy??
some e bay sellers dont know carp bout the ls theres a fuel managment controller listed ....for those injected savages!!!

Title: Re: Saddle bag supports
Post by verslagen1 on 01/11/08 at 14:01:10

Steve_Rocket mounted his on the outside of the fender. I may do the same once I get around to it.

Title: Re: Saddle bag supports
Post by thumperclone on 01/11/08 at 18:07:45

677463627D7076747F20110 wrote:

Steve_Rocket mounted his on the outside of the fender. I may do the same once I get around to it.

under the side rails? or no rails at all?

Title: Re: Saddle bag supports
Post by verslagen1 on 01/11/08 at 18:47:48

between the fender and the shiney supports

Title: Re: Saddle bag supports
Post by thumperclone on 01/11/08 at 22:01:35

5E4D5A5B44494F4D4619280 wrote:

between the fender and the shiney supports

got it bit of a gap for a bungee...