SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> installing new carb to engine gaskett /cgi-bin/YaBB.pl?num=1196020409 Message started by DocNeedles on 11/25/07 at 11:53:29 |
Title: installing new carb to engine gaskett Post by DocNeedles on 11/25/07 at 11:53:29 I did get the old carb gasket off with an impact screwdriver. Thanks all for your help. So now my problem is should I put locktite on the new hex bolts going into the new gasket, and what should I torque the new bolts down to? I haven't found mention of the torque in my manual and haven't found it listed in the great tech torque list section. Any advise would be greatfully appreaciated!! DocNeedles |
Title: Re: installing new carb to engine gaskett Post by LANCER on 11/25/07 at 14:01:28 I have never found thread lock to be necessary. I use lock washers with flat washers and hex head stainless bolts. I just snug them up gently and use my torque calibrated wrist. |
Title: Re: installing new carb to engine gaskett Post by rigidchop on 11/25/07 at 14:48:08 yeah dont snug too hard or youll crack it. |
Title: Re: installing new carb to engine gaskett Post by gj859 on 11/25/07 at 15:09:30 Hey Doc I don't mean to steal your thread, but what doe's everyone think about antisieze? I do have a reason for asking, but didn't want to start a new thread. thanks. |
Title: Re: installing new carb to engine gaskett Post by Reelthing on 11/25/07 at 19:42:13 most of the time steel (s/s also) bolts I put into aluminum get hitemp antisieze |
Title: Re: installing new carb to engine gaskett Post by vroom1776 on 11/26/07 at 13:18:45 yep, anti-sieze is your friend. I also use it on the exhaust header bolts. |
Title: Re: installing new carb to engine gaskett Post by DocNeedles on 11/26/07 at 14:53:59 gj859 wrote:
No problem about stealing my thread , the information is useful to me also. DocNeedles |
Title: Re: installing new carb to engine gaskett Post by gj859 on 11/26/07 at 15:04:33 DocNeedles wrote:
Thanks Doc and everyone the people on this forum are the nicest I've ever had contact with. |
Title: Re: installing new carb to engine gaskett Post by Savage_Rob on 11/27/07 at 10:17:23 Reelthing wrote:
Yup, I've started doing that too, especially in high temp areas. http://www.royalenfieldusa.com/gz/images/CopperAntiSeizeZ90863.jpg |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |