SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Adjusting spline at the transmission /cgi-bin/YaBB.pl?num=1188691950 Message started by forrest on 09/01/07 at 17:12:30 |
Title: Adjusting spline at the transmission Post by forrest on 09/01/07 at 17:12:30 In a thread in the Cafe it was mentioned to adjust the spline at the transmission to raise the shifter a couple of notches. How this this done? |
Title: Re: Adjusting spline at the transmission Post by Max_Morley on 09/01/07 at 17:20:31 Well that is the old way. On the Savage there is a turn buckle between the shift lever and shift shaft. Loosen the lock nuts (one is RH thread and the other LH -look to see which is which) and if you make the turnbuckle longer it will raise the pedal tab. Max |
Title: Re: Adjusting spline at the transmission Post by demin on 09/01/07 at 17:22:28 If you look where your shift shaft comes out of the motor it has a splined shaft,on yhat there is a splined arm.Take a sharpie and mark across both pieces,then there is a small pinch bolt remove it slide the arm off of the shaft(may take a little work).Move the arm clock- wise to raise it.Counterclockwise to lower it.Probably just a tooth or 2 either way |
Title: Re: Adjusting spline at the transmission Post by forrest on 09/01/07 at 17:25:03 Thanks, I'll try it tommorow. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |