SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Exhaust question /cgi-bin/YaBB.pl?num=1186922741 Message started by Baldeagle on 08/12/07 at 05:45:41 |
Title: Exhaust question Post by Baldeagle on 08/12/07 at 05:45:41 Will be pulling exhaust and replacing gaskets.......these are metal..........do I need to use a sealer???? The dealer suggested using something like Yamalube. As always your advise is highly appreciated. Not being anywhere near being a gear head...through this site I have done the the spacer mod, seat mode,etc. :) My computer is located in the garage and with our temps being 100+ I'm limited to how long my computer time is. Aaaaaaah.....heated in the summer and air conditioned in the winter.....GREAT! |
Title: Re: Exhaust question Post by justin_o_guy2 on 08/12/07 at 08:57:25 MIne came oout looking dry. Replaced without any "Goo" anywhere. No one said anything about Goo. It's a crush washer, really. When you see the one that came out & compare to the new, you will see how it seals. Just clean the head & header up so theres nothing poking up that will keep it from making contact all across each side. Remember to retorque those bolts cold after a bit of riding. |
Title: Re: Exhaust question Post by Baldeagle on 08/12/07 at 13:39:18 Thanks and thanks again for 152.5 main. I typed Yamalube but meant Yamaseal. Had not idea these were crush seals |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |