SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Drive pulley nut size? /cgi-bin/YaBB.pl?num=1186423160 Message started by jkhulon73 on 08/06/07 at 10:59:20 |
Title: Drive pulley nut size? Post by jkhulon73 on 08/06/07 at 10:59:20 My calipers dissappeared, I don't own a socket even close to the size, and I couldn't find the answer using the search function (and it's too d@mn hot to be farting around in the garage, on my hands and knees with a ruler anyway :P) So, if someone could please tell me what size socket I need to remove the front drive pullet, I'd really appreaciate it... Putting the new drive belt on is the last thing mechanical thing I need to do before I start rewiring the bike (and then hopefully ride it) Thanks. |
Title: Re: Drive pulley nut size? Post by T-Mack1 on 08/06/07 at 11:07:45 Just went down to Auto-zone this past weekend with my nut (also same size as clutch nut). Found a thirty something (I think it was 32 mm) BUT.......the 1 1/4 inch 6 faced socket fit tighter on both nuts. It wasn't much tighter. |
Title: Re: Drive pulley nut size? Post by verslagen1 on 08/06/07 at 11:31:34 32mm = 1.25984" I bet standard clearances are around .010" But with a 6 point you can getaway with a lot more. |
Title: Re: Drive pulley nut size? Post by jkhulon73 on 08/06/07 at 13:34:33 much a$$ gra$$y a$$ ;D |
Title: Re: Drive pulley nut size? Post by jkhulon73 on 08/06/07 at 15:14:26 Yep- 32 mike mike. Easy-peezy lemon squeezy. So far, that's been the easiest part of this whole mess. My hands still hurt like hell from mounting the new tire on the rear rim- just getting that 90-degree valve stem in was enough drive a man nuggin' futs... |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |