SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Gas valve -- PRI
/cgi-bin/YaBB.pl?num=1185405703

Message started by Paladin on 07/25/07 at 16:21:43

Title: Gas valve -- PRI
Post by Paladin on 07/25/07 at 16:21:43

Had to drain the tank -- pulled the hose off the carb, stuck it into the nozzle of my 5 gal jerry can (perfect height match!) and switched to prime.  Many minutes later it had stopped running, so I pulled the gasoline valve off to remove the tank (so much easier) and no more than a quarter tsp of gasoline dribble out.

Someone asked, the answer is:

PRI gets right to the bottom of the tank.

Title: Re: Gas valve -- PRI
Post by toddlamp8 on 07/25/07 at 18:17:32

I had asked that before in another thread.  Thanks, because I run the bike off of PRI to bypass the diaphragm

Title: Re: Gas valve -- PRI
Post by Savage_Rob on 07/26/07 at 04:54:23

The most logical reason for that is so you can prime the carb when starting after running out of fuel using ON/RUN.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.