SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Where does the Prime selection feed from?
/cgi-bin/YaBB.pl?num=1184988806

Message started by toddlamp8 on 07/20/07 at 20:33:26

Title: Where does the Prime selection feed from?
Post by toddlamp8 on 07/20/07 at 20:33:26

I have been running my bike from the prime location on the fuel valve since I suspect my stalling was from a diaphragm problem. My question is where in the tank does this selection feed from (reserve or on stalk)? I am assuming the reserve but would like to know for sure.

Thanks.

Title: Re: Where does the Prime selection feed from?
Post by Savage_Rob on 07/20/07 at 20:38:21

I'm guessing that by "stalk" you mean the petc0ck's vertical tube. All three settings feed from that assembly. ON/RUN feeds from a higher position in the assembly while both PRI and RES feed from the lower point.

Title: Re: Where does the Prime selection feed from?
Post by toddlamp8 on 07/20/07 at 20:43:55

Yeah I was referring to the piece that going into the tank even though there are two tubes inside.

Thanks for letting me know!