SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> New cam and rocker arm /cgi-bin/YaBB.pl?num=1184705661 Message started by rickyt23 on 07/17/07 at 13:54:21 |
Title: New cam and rocker arm Post by rickyt23 on 07/17/07 at 13:54:21 I just put a new cam and rocker arm in my savage and I'm not sure how to adjust the valves I have the all the way out with the cam touching the rocker and it seems as though theres no adjustment. Should I not have the cam rotated up?? |
Title: Re: New cam and rocker arm Post by youzguyz on 07/17/07 at 13:59:57 Adjustment is made at TDC (top dead center) on compression stroke. (both valves closed). Read this.. and related. http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1151938664 |
Title: Re: New cam and rocker arm Post by rickyt23 on 07/17/07 at 17:17:49 Ok the cams in and the rocker arm screws were adjusted I put the covers on fired it up. It sounded good now I put it all back together including the tank and it won't start?? any suggestions out there?? Thanks for the help!! |
Title: Re: New cam and rocker arm Post by justin_o_guy on 07/17/07 at 22:01:34 Did you run it outta gas without the tank hooked up? If so, the carb bowl is empty & you need to put it on "PRI" on the petcock. Note the little arrow on the lever. POint it to PRI. I hope thats it. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |