SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Making the most out of a goof. /cgi-bin/YaBB.pl?num=1183083898 Message started by Trippah on 06/28/07 at 19:24:58 |
Title: Making the most out of a goof. Post by Trippah on 06/28/07 at 19:24:58 Hi everyone, loking for your thoughts and suggestions. Broke a stud of the exhaust header..see large heat shield thread for specifics. Anyway, now that I have to take the top end of the motor off, what mods would you do to make the most of this bad situation. I am thinking I'd like the camshaft Lancer does, and will need to open up the carb and exhaust (Well, it as open as it can get right now, I realize :o) I guess the question is to have it bored out for a larger piston? I'm not thinking i'd like to increase compression all that much.. So, what mods would you do given the unplanned engine top end job?? |
Title: Re: Making the most out of a goof. Post by Reelthing on 06/28/07 at 19:56:33 whats the budget and how long can it be out of service? |
Title: Re: Making the most out of a goof. Post by Trippah on 06/28/07 at 20:03:02 Out of service..well, a month I could accept. Budget, haven't thought about it enough, maybee $500-$700.? Had kinda budgeted $500. for tuneup/ cosmetics (paint job). |
Title: Re: Making the most out of a goof. Post by Max_Morley on 06/28/07 at 20:39:24 I'd helicoil it in place and ride until winter rather than waste a riding day/week/month. Max |
Title: Re: Making the most out of a goof. Post by vroom1776 on 06/29/07 at 10:54:40 bolt should come out easy if you can get a drill in there. How to use a Rigid Screw Extractor (http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1159393743) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |