SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Gas cap gasket - any ideas /cgi-bin/YaBB.pl?num=1182521300 Message started by Thumpin on 06/22/07 at 07:08:20 |
Title: Gas cap gasket - any ideas Post by Thumpin on 06/22/07 at 07:08:20 I need to replace the gasket under my gas cap. The obviusly custom job the the PO put on here is #1 worn out and #2 sucked to begin with. I thought I would see if I could get the actual gasket from the stealership. His response was that I would have to buy a entire gas cap cause they can't get just the gasket. What about the keying was my 2nd thought after making it through my 1st thought of how f-ing stupid is this. This has to be a common part to replace. Ideas out there????? |
Title: Re: Gas cap gasket - any ideas Post by barry68v10 on 06/22/07 at 15:57:30 I took an old bike tube and cut to a circle the same size as the gas cap. Cut a hole in the center just smaller than the inside of the cap and pulled it over the inside of the gas cap. I seals perfectly and I no longer leak gas down the tank no matter how full the tank is. |
Title: Re: Gas cap gasket - any ideas Post by barry68v10 on 06/22/07 at 15:58:52 Not a "factory" job I know, but it took me 3 whole minutes and cost me NOTHIN! ;D |
Title: Re: Gas cap gasket - any ideas Post by justin_o_guy on 06/22/07 at 19:02:53 Yea, but if ya seal it too good it'll suck a dent in the tank..... Ha! I got there First! Good deal, mine leaks & has from day one. I'm gonna do that. |
Title: Re: Gas cap gasket - any ideas Post by Thumpin on 06/23/07 at 17:36:45 Sounds like a plan. I will try your "field expedient method". |
Title: Re: Gas cap gasket - any ideas Post by YonuhAdisi on 06/23/07 at 21:00:24 barry68v10 wrote:
That's exactly how I made a gasket for my fuel cap. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |