SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Parts from aGZ250 to fit the LS650? /cgi-bin/YaBB.pl?num=1176666491 Message started by Scottwerty on 04/15/07 at 12:48:10 |
Title: Parts from aGZ250 to fit the LS650? Post by Scottwerty on 04/15/07 at 12:48:10 Just found this bike surfing the web http://www.bettencourts.com/new_vehicle_detail.asp?sid=09840357X4K15K2007J2I31I40JPMQ1133R0&veh=24534&pov=518566 I was wondering how simular it is to our savage! wonder if we could take some parts off this model for the savage? Comments, suggestions? |
Title: Re: Parts from aGZ250 to fit the LS650? Post by Scottwerty on 04/15/07 at 13:05:53 Maybe the tank? Fuel Tank Capacity: 14.0 liter (3.7 gal.) 13.0 liter (3.4 gal.) CA. Model . Just a thought |
Title: Re: Parts from aGZ250 to fit the LS650? Post by Max_Morley on 04/15/07 at 13:33:08 I always thought the front fender had nice lines to it. |
Title: Re: Parts from aGZ250 to fit the LS650? Post by Scottwerty on 04/15/07 at 13:37:51 And I bet its a straight bolt on. the forks look the same |
Title: Re: Parts from aGZ250 to fit the LS650? Post by Max_Morley on 04/15/07 at 13:39:25 Seems like I measured when the 250's were new and it is much wider. Max |
Title: Re: Parts from aGZ250 to fit the LS650? Post by Scottwerty on 04/15/07 at 14:05:17 How much wider? could possibly use triple tree from a gz to get width if forks are the same |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |