SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> what is thickness of stock white spacer?
/cgi-bin/YaBB.pl?num=1168233363

Message started by w6k on 01/07/07 at 21:16:03

Title: what is thickness of stock white spacer?
Post by w6k on 01/07/07 at 21:16:03

My 2002 has a 152.5 main jet in it. I pulled the carb to do the spacer mod but maybe it was done when the main was changed to accomodate the Supertrapps the previous owner installed. Not sure at this point because I don't know the the thickness of a stock spacer. The one that is in there now looks to be about 3/16" or so.

Title: Re: what is thickness of stock white spacer?
Post by justin_o_guy on 01/07/07 at 23:03:11

Digital dial callipers say .111 on the stock white spacer

Title: Re: what is thickness of stock white spacer?
Post by Hashbrown on 01/08/07 at 07:30:59

basically you want to look for wear or rubbing. if one side is flatter then the other then you know its been shaved. if it looks uniform then it hasnt been touched

Title: Re: what is thickness of stock white spacer?
Post by slavy on 01/08/07 at 15:47:18

2.5 mm

Title: Re: what is thickness of stock white spacer?
Post by w6k on 01/08/07 at 18:31:02

OK I have two answers 2.5mm and .111 inches. I suspect there is some varience in the thickness from spacer to spacer so allowing for that means the thicknes is somewhere between 2.5 and 2.8 mm. That is less than 1/8." My spacer is stock. Thank you gentleman for your help.

Title: Re: what is thickness of stock white spacer?
Post by justin_o_guy on 01/08/07 at 19:06:35

I went & rechecked my measurement after I saw the other one. It is, according to the digital dial calliper, which I checked the zero on, .111 inches.