SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Head Cover Removal /cgi-bin/YaBB.pl?num=1160595930 Message started by vroom1776 on 10/11/06 at 12:45:30 |
Title: Head Cover Removal Post by vroom1776 on 10/11/06 at 12:45:30 Hey Gang, Two questions about removing the engine head cover... 1) Is it necessary to remove the L70* bolt to remove the headcover? See this diagram (http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1099227295;start=0#3). Greg_650 says it comes off w/ the head cover... 2) Once all the bolts are removed, how hard should it be to actually remove the head cover? Any suggestions on where to pull or pry? I do not want to break any fins... As a note, the factory service manual says not to remove the S30* bolt. This one keeps the cam in place... Thanks, V |
Title: Re: Head Cover Removal Post by bentwheel on 10/11/06 at 15:00:38 I recall there was one bolt that did not have to be removed. It is likely the one Greg refers to. I found it best to remove the cover by twisting it forward to clear the cam sprocket, then pulling it out to the left side. |
Title: Re: Head Cover Removal Post by steelwolf on 10/11/06 at 16:06:02 I pulled mine out to the right side and I took out the L70 bolt as well. But then again I also took the engine mounts off of the frame for better clearance. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |