SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Decompressor Assembly /cgi-bin/YaBB.pl?num=1157438969 Message started by LeeLee on 09/04/06 at 23:49:29 |
Title: Decompressor Assembly Post by LeeLee on 09/04/06 at 23:49:29 Hi! I am a motorcycle newbie. I took the safety class, got my endorsement, and found my Savage in May. Since May I have logged 2500 miles. I have been loving every minute I am able to spend on the bike. ;D I did the newbie thing one night after a ride with friends, forgetting to turn the key off, and killed the battery. To add insult to injury when I got the battery jumped (cause we couldn't compression start it) We hit construction traffic that lasted 2 hours and overheated the engine. I replaced the oil since I was told that I "cooked" the previous oil. But since then I have a slight oil leak. I have traced it to (as my Clymers manual) calls it, the decompressor assembly (oil seal) that sits on the top of the cylinder. I need to replace the oil seal and the sealing washer in hopes that this will stop the leak, it is getting worse. I have been looking online but I am having a tough time finding the parts in the schematics that I've seen. Could anyone out there please help me? Maybe I am looking on the wrong schematic, or maybe it is called something else, or maybe what I am looking for is a common part used in many places? Please help! ??? Thanks |
Title: Re: Decompressor Assembly Post by Kropatchek on 09/05/06 at 04:35:45 Check out this schematic. The items you're looking for are #22 and # 27. Hope to be of help. http://www.ronayers.com/fiche/300_0271/cam_shaft_valve/cam_shaft_valve.cfm Greetz Kropatchek 8) |
Title: Re: Decompressor Assembly Post by LeeLee on 09/05/06 at 09:03:36 Thank you sooo much! I knew that I could count on my brothers and sisters on this site. Newbie LeeLee |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |