SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Help? Plate Above the Carb Needle /cgi-bin/YaBB.pl?num=1153515321 Message started by platinum_ghost on 07/21/06 at 13:55:21 |
Title: Help? Plate Above the Carb Needle Post by platinum_ghost on 07/21/06 at 13:55:21 New poster here. I am doing the white spacer mod and rejetting, however the metal plate above the spacer has one little bump/knub on it and I don't know if it should face up or down. Anyone here know, up or down? |
Title: Re: Help? Plate Above the Carb Needle Post by SeeAPierce on 07/21/06 at 15:01:17 Dimple down... http://suzukisavage.com/cgi-bin/YaBB.pl?board=RubberSideDown;action=display;num=1123171986;start=61#61 |
Title: Re: Help? Plate Above the Carb Needle Post by platinum_ghost on 07/21/06 at 15:10:07 Thanks for the quick reply. I looked at it again before I saw your reply and said "Duh!". One way only. Thanks! |
Title: Re: Help? Plate Above the Carb Needle Post by JerryAssburger on 07/21/06 at 16:03:09 Don't feel bad. I sat and stared at mine for an hour before I figured it out. ??? |
Title: Re: Help? Plate Above the Carb Needle Post by MacAttack on 07/21/06 at 16:22:51 Yeah, don't feel bad, I didn't put the assembly together properly the first time, either! |
Title: Re: Help? Plate Above the Carb Needle Post by SavageDude on 07/21/06 at 20:17:50 That's part of the fun in tinkering ;D |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |