SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Need help with some fender chop ideas
/cgi-bin/YaBB.pl?num=1141354152

Message started by Grant Inge on 03/02/06 at 18:49:12

Title: Need help with some fender chop ideas
Post by Grant Inge on 03/02/06 at 18:49:12

Hey i got my savage a few weeks ago i love it.. theres a few dents here and there.. but im doing the bodywork and painting next week at work... im wanting somthing diffrent with the rear fender... like cut out everything from the extra seat back... just wonderd how it would look... any ideas on color, im getting it done at work so, all i pay is cost... any ideas and pics? thanks....

Title: Re: Need help with some fender chop ideas
Post by SAMM on 03/02/06 at 19:04:26

Go to (show us your ride) Sluggo has done what you may be looking for....Bob tail

Title: Re: Need help with some fender chop ideas
Post by SAMM on 03/02/06 at 19:06:24

P/S I beleave his fenders are suzuki GN400 fenders

Title: Re: Need help with some fender chop ideas
Post by Paladin on 03/02/06 at 20:32:35

The turn signals, tail/stop light, license plate and plate light all mount on the tail of the rear fender/siderails. Any bobbing of the tail will require relocating, replacing, or removing all of these. The run/stop light kit I added to my turn signals would allow you to lose the stock run/stop light. Or if your state does not require them you could lose the turn signals and just run a single run/stop/license lamp. Your possibilities are limited only by imagination and state vehicle code.

Title: Re: Need help with some fender chop ideas
Post by klx650sm2002 on 03/03/06 at 03:57:19

If it were me I would rotate the rear fender clockwise (viewed from right) so that it went straight back not back and down like std.

Clive W :D

Title: Re: Need help with some fender chop ideas
Post by Jim_R on 03/03/06 at 07:03:35

I remember when I was toying with the idea 6 months ago. Torque showed me the trailor fender selection at Northern Tool I believe. There were a couple of options and they didnt look too bad if ya painted them. I like the chrome gn400 look but I wish it was a little longer.

check ebaymotors for a gn400 and good luck

Title: Re: Need help with some fender chop ideas
Post by klx650sm2002 on 03/04/06 at 01:29:37

If the fender went straight back you could put the light and plate underneath.

Clive W :D

Title: Re: Need help with some fender chop ideas
Post by Bobster on 03/04/06 at 07:02:26

Jim_R wrote:

yes, a lil longer.

Title: Re: Need help with some fender chop ideas
Post by lancer on 03/04/06 at 22:43:20

Jim_R wrote:

I looked at the fenders at the Northern Tool store this past week, and have about decided to get one. They are made of decent steel and are low priced as well.