SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> front fork dust seal install /cgi-bin/YaBB.pl?num=1096846936 Message started by charliebrown on 10/03/04 at 16:42:16 |
Title: front fork dust seal install Post by charliebrown on 10/03/04 at 16:42:16 i had one of my front fork seals replaced and when i got my fork back it was missing the dust seal(the little peice of rubber where the two toobs come together).i was wondering what the install intailed. is it just a matter of slipping it on and seating it or is there some adheisive required? anyway you guys have been very help full and i thank you. |
Title: Re: front fork dust seal install Post by Honda_fan on 10/03/04 at 16:56:32 I haven't done the Savage's but on my other bikes they just slide over the tube and lock in a retaining groove on the lower leg. |
Title: Re: front fork dust seal install Post by Greg_650 on 10/04/04 at 02:17:52 Honda_fan wrote:
Same here, but according to the book you are right. It should just slide on. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |